3DR ArduCopter Quad-C 사용자 설명서 - 페이지 7

{카테고리_이름} 3DR ArduCopter Quad-C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR ArduCopter Quad-C 19 페이지.

Arm Assembly x4

Note: If assembling a quad kit prior to Revision-C and installing 880kv (orange) motors the

centered hole on the arm that allows room for the shaft to poke through needs to be drilled out

to 10mm.

1. Attach the motor to the arm using two M3x5mm screws (Blue) and two M3 lock

washers (Orange) making sure the screws go into the threaded holes in the motor

and not the ventilation holes. (If the motor is screwed using the ventilation holes, it

will not spin freely) Route the motor cables through the hole on the side of the arm.

2. Use two M3x25mm screws (Green) and two M3 metal nuts (Pink) to fasten the legs

to the arm using the indicated holes. To provide rigidity to the legs attach two

M3x18mm spacers in between the legs and secure with four M3x5mm metal

screws (Blue).

3. Repeat for all 4 arms.