3DR ArduCopter Quad-C 사용자 설명서 - 페이지 9

{카테고리_이름} 3DR ArduCopter Quad-C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR ArduCopter Quad-C 19 페이지.

Main Frame Assembly

1. Attach the bottom and top plates to one of the arm assemblies using an M3x30mm

screw (Blue) and an M3x25mm screw (Green), secure with two M3 metal nuts (Pink).

Note the four screws closer to the center of the vehicle are longer than those on the outside.

This 4 longer screws will be used to hold the PDB cap and stack-up assembly.

2. Repeat for the other three arms.

3. Attach four M3x08mm spacers as indicated in the ﬁgure above and fasten using four

M3x5mm nylon screws (Red).

4. Slide the velcro straps through the two slots on the bottom plate. The velcro straps

will be used to fasten the ﬂight battery bellow the vehicle.

5. Slide four rubber washers (Orange) onto the M3x30mm screws (Blue) that stick out

of the top plate.