- ページ 16

計測機器 Divesoft DNA 8460のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Divesoft DNA 8460 18 ページ。

11/24/23, 1:33 PM

2. Download the external nRF Device Firmware Update

application and run it.

3. Pull out the bottom of the analyzer.

4. Start the bootloader - Press the button in the hole in the

bottom of the analyzer for 6 sec. To press the button, use, for

example, a SIM card removal tool or a paper clip, etc. If the

bootloader is successfully switched, the LED next to the

battery inside the bottom of the analyzer lights up for 1 sec in

red and then the red and green LEDs flash alternately.

5. In the application, select the downloaded firmware file.

6. Select the DNA analyzer. In the application it is displayed as

DNA-DFU (only if switched to bootloader). The serial number is

not displayed.

7. Press START in the application.

8. After the firmware is loaded, the new firmware will

automatically start.

NOTE: Should an error occur during upload, the device will

remain in bootloader mode and the action can be repeated. In

case of inactivity for 2 minutes, the analyzer will switch back to

standard mode.

3.4 Used sensors and batteries

Treat used oxygen sensors as hazardous waste. Use collection

points or containers designed for the collection of used

batteries.

Dispose of used batteries in designated collection containers

or take them to a collection point.

https://www.divesoft.com/en/manuals/8460-dna-user-manual?_ga=2.264787596.209083188.1700850446-662384236.1700850430

#8460 DNA User Manual

16/18