- ページ 10

3Dプリンター 3DUpFitters CR-10 Smart Enclosure KitのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters CR-10 Smart Enclosure Kit 19 ページ。

Attach the door hinges, latch mounts, strike plates, and the knob, and the assembly

will look like the illustration to the right. Don't forget the mid-panel connectors at the

back left and top.

As with the front door, adjust how the door hangs by loosening the hinge screws, using

the strike plates to hold the door to the latches, and then tightening the hinge screws.

Note that you'll need to bend the strike plates slightly to hold onto the thinner

acrylic on the side.

4. Assemble Back

The back of the enclosure when viewed from the

back is shown to the right. The four corner

connectors are mirror images of the front. The large

hole is either for an air ﬁlter (purchased separately)

or can be covered up 3D printing a cover using M4

10mm screws. (There's a link to the cover on the

product page.)

On the top and on each side are "mid panel corner

connectors", which are basically simple L-shapes.

The large 80mm hole is either for the included fan by itself, an air ﬁlter (purchased

separately)/fan combo, or it can be covered up by a plastic disk depending on how

much air ﬂow you want.

Note that the fan, either by itself or paired with a ﬁlter or vent is necessary to draw air

over the power supply. This both heats up the air inside the enclosure AND cools

down the power supply, which extends its life. Only use the circular disk (not included)

to cover up the hole if you have moved the power supply outside of the enclosure, or if

you simply don't care about power supply longevity which is not unreasonable given

the small chance of a power supply failure.