- ページ 11

3Dプリンター 3DUpFitters CR-10 Smart Enclosure KitのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters CR-10 Smart Enclosure Kit 19 ページ。

Conﬁrm the direction of the fan by plugging it into a

USB power supply before attaching the ﬁlter. The round

label should be on the outside

The fan should be attached on the outside of the

enclosure.

The fan should be oriented to pull air OUT of the

enclosure.

Use the long screws included in the fan packet to attach

the fan. The length of the screws may change

depending on the depth of this particular shipment of fans.

If attached the Charcoal Air Filter instead follow the directions included with that

product.

At the bottom is a slit for the grommet

and grommet holder. The grommet is

used to get the power cable and other

cables into the enclosure. Once the

cables are through the grommet you

can lift the enclosure oﬀ without having

to unplug anything.

Now attach the back to the assembled

left and front panels, which should look like

the illustration to the right.