- ページ 8

3Dプリンター 3DUpFitters Ender 3 S1 Enclosure KitのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters Ender 3 S1 Enclosure Kit 17 ページ。

2. Left Side Panel

Attach the left side to the front forming an L-shape that will stand up on its own, then

attach one L and one R connector at the back. The Ender 3 S1 design technically

doesn't need a door, but it allows for additional access to the extruder. The latch

mounts are smaller than the front, although the magnetic latch attaches in the same

way with wood screws. The parts for the side door will be in a separate packet.

Attach the door hinges, latch mounts, strike plates, and

the knob, and the assembly will look like the illustration to

the right. Don't forget the mid-panel connectors at the

back left and top.

As with the front door, adjust how the door hangs by

loosening the hinge screws, using the strike plates to hold

the door to the latches, and then tightening the hinge

screws.

Note that the left side will also be the location of the fresh air intake vent, but that will

be installed after the enclosure is placed over the printer.