- ページ 9

3Dプリンター 3DUpFitters Ender 3 S1 Enclosure KitのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters Ender 3 S1 Enclosure Kit 17 ページ。

3. Back Panel

The back of the enclosure is shown below. The four corner connectors are mirror

images of the front. The large hole is either for an air ﬁlter (purchased separately) or

can be covered up by the included plastic disc using M4 12mm screws. On the top

and on each side are "mid panel corner connectors", which are basically simple L-

shapes.

Make sure the fan is blowing air out of the

enclosure and NOT into it. Conﬁrm the direction of

the fan by plugging it into a USB power supply

before attaching the ﬁlter. The round label should

be on the outside

The fan should be attached on the outside of

the enclosure.

The fan should be oriented to pull air OUT of the

enclosure.