- ページ 7

ラック＆スタンド 3DUpFitters CR-10 S4のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters CR-10 S4 15 ページ。 Enclosure kit

At this point attach the latch mount to the front

door frame using the included 30mm M4 screw.

Attach the hinges to the door and door frame using

M4 ﬂat head 12mm screws and nuts. There will be

some play in the hole size so that you can adjust the

door to swing freely.

Attach the door knob using a 12mm ﬂat head screw

and nut.

Now that the latches are mounted it is time to connect the strike plates. Each plate

comes with a squishy adhesive covering the same size of the plate. Carefully attach

the adhesive side to the acrylic at the location of each latch. Then, adjust the width of

the metal strike plate so that it is held on by the pressure of the two sides of the plate.

The adhesive covering will keep the metal of the strike plate from scratching the

acrylic.

3. Attach Left Side

Attach the left side to the front forming an L-

shape that will stand up on its own, then

attach one L and one R connector at the

back.

The CR-10 S4/S5 design adds a side door for

each access to the printer, which is

assembled at this time. The latch mounts

are smaller than the front, although the

magnetic latch attaches in the same way

with wood screws. The parts for the side

door will be in a separate packet.