- ページ 10

サーモスタット ESI ESRTP4RFのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。ESI ESRTP4RF 20 ページ。 Rf programmable room thermostat
ESI ESRTP4RF にも：ユーザーマニュアル (20 ページ)

date which is automatically set together with the

actual room temperature.

Fitting the Receiver

2.7

Installation

1. Loosen the screws on the back-plate and remove from

the Unit.

2. Fix the back-plate, terminals at the top, either direct

onto a flat wall using wall plugs and screws or on a flush

mounting single conduit box. Route the wires through

the back of the wall plate and fit the wires to the wall-

plate in accordance with the relevant diagram and in

accordance with I.E.E. regulations.

3. Fit the Unit onto back-plate, and tighten the screws.

4. Ensure an appropriate fuse is fitted to the circuit before

reconnecting to the mains supply.

2.8

1. If the receiver and thermostat have been supplied as

a kit, the units have already been paired in the factory

and no pairing is needed.

2. Power up the receiver and press M/A (Manual/Auto)

button

MANUAL (green) light

3. On the thermostat, switch the slider to OFF. Press and

hold the A, H and + buttons for 3 seconds until the

symbol flashes.

4. When the light on the receiver stops flashing the two

units are paired.

5. If unsuccessful, repeat steps 2-3. If still unable to pair,

leave the unit powered on for 5 minutes and repeat the

steps above.

for approximately 10 seconds until the

begins to flash.