ESI ESRTP4RF Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Termostat ESI ESRTP4RF. ESI ESRTP4RF 20 stron. Rf programmable room thermostat
Również dla ESI ESRTP4RF: Instrukcje użytkownika (20 strony)

Drukuj stronę

date which is automatically set together with the

actual room temperature.

Fitting the Receiver

2.7

Installation

1. Loosen the screws on the back-plate and remove from

the Unit.

2. Fix the back-plate, terminals at the top, either direct

onto a flat wall using wall plugs and screws or on a flush

mounting single conduit box. Route the wires through

the back of the wall plate and fit the wires to the wall-

plate in accordance with the relevant diagram and in

accordance with I.E.E. regulations.

3. Fit the Unit onto back-plate, and tighten the screws.

4. Ensure an appropriate fuse is fitted to the circuit before

reconnecting to the mains supply.

Commissioning/Configuring

2.8

1. If the receiver and thermostat have been supplied as

a kit, the units have already been paired in the factory

and no pairing is needed.

2. Power up the receiver and press M/A (Manual/Auto)

button

MANUAL (green) light

3. On the thermostat, switch the slider to OFF. Press and

hold the A, H and + buttons for 3 seconds until the

symbol flashes.

4. When the light on the receiver stops flashing the two

units are paired.

5. If unsuccessful, repeat steps 2-3. If still unable to pair,

leave the unit powered on for 5 minutes and repeat the

steps above.

for approximately 10 seconds until the

begins to flash.