- ページ 7

ホームシアターシステム ACOUSTIC SOLUTIONS DS 1133のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ACOUSTIC SOLUTIONS DS 1133 13 ページ。

LOUDSPEAKER CONNECTIONS

NOTE: Please ensure that the DS 1133 is switched off before connecting

any speaker leads

Ensure the correct polarity (+) and (-) of all speaker leads. Check to make

sure there are no wires touching on the speaker terminals, and that all wires

are ﬁrmly clamped into the terminals (7, page 3).

FRONT L

DS-1133 SPEAKER OUT TERMINALS

REAR L

CENTRE

REAR R

REAR L

FRONT L

FRONT R

CENTRE

SPEAKERS OUT

The speaker terminals on the rear of the DS 1133 and rear of the speakers

have corresponding colour coded markings to ease identiﬁcation.

NOTE: When inserting speaker cables into any of the terminals, the black

wire should be ﬁtted into the - (negative) terminal, The grey wire into the +

(positive) terminal.

FRONT R

Please see the supplied Fast Setup sheet for hints and tips on connecting

and positioning of your speakers.

Now that you have connected your speakers to their correct terminals, you

can use the test function to ensure that all speaker are connected.

Selecting the TEST button on the remote control (12, page 4) activates the

test function. The test function outputs a white noise signal to each of the

satellite speakers and subwoofer in turn in the following order:

FRONT LEFT - CENTRE - FRONT RIGHT - REAR RIGHT - REAR LEFT - SUBWOOFER

REAR R

To switch off the test function, press the TEST button on the remote control

again.

If you do not hear a test noise from some of your speakers, switch off the

system and check the connections.