アクセサリー ABC Spa Cover Removal Universal Spa Cover LifterのPDF 組み立ておよび使用方法をオンラインで閲覧またはダウンロードできます。ABC Spa Cover Removal Universal Spa Cover Lifter 2 ページ。
ページを印刷するU.S. Patent #6,000,072
Directions for
Assembling,
Installing
and Using the
Universal Spa
Cover Lifter
Your UNIVERSAL Spa Cover
Lifter requires minimal assembly
after it is unpackaged.
To assemble and install:
1.
Remove the tape and 1/2" #8 self-drilling screw
from Adjustment Bar B.
2.
Insert Connector Bar A into
Adjustment Bar B and
fasten with the 1/2"
#8 self-drilling screw.
3.
Place Connector Bar A
on the spa cover
center seam.
4.
While sliding the Adjustment Bar B out of the Pivot Bar C,
locate where you want to mount the UNIVERSAL Spa Cover
Lifter on your spa or deck.
Note: if mounting on deck, brackets F1 and F2
must first be turned 90
5.
End of Main Bar E with Bracket F1 should be fastened to the spa or
deck 26" from the end of the spa using 1-1/4" screws. Bracket F2
must be mounted as close to Pivot Bracket D as possible
(minimum 6" from Bracket F1 ).
Note: Spa cabinets with little backing or lightweight material
where the UNIVERSAL Cover Lifter is to be fastened
may need to be reinforced in that area.
F1
Mounted
6" min.
on Side
of Spa
26"
A
B
A
on Main Bar E.
O
C
F2
D
E
tel: (604) 856-0275
fax: (604) 556-0244
www.spacoverremover.ca
Canadian Patent #2,282,012
I
H
G
A
B
A
To assemble and install (continued):
5a.
If the cover lifter is to be mounted
on the deck, the Mounting Brackets
F1 & F2 must be located so that Main
Bar E is 1" from the side of the spa
cabinet. This distance (1") may vary,
depending on the top trim of spa.
Customers of deck-mounted
UNIVERSAL Cover Lifters can
purchase a Mounting Foot for ease of installation.
6.
Slide Bar G into Bar H.
7.
Make sure that the combined width
of Bars G/H is long enough
so each Adjustment Bar B
is parallel to the side of
the spa when attached.
If an adjustment is
needed, Bars G/H may be
cut so that the sides are not flaring in or out. Trim Sleeve I to the
same length as the combined length of Bars G/H. Remove one
Adjustment Bar B from the sleeve, then attach Bars G/H to it.
Slide Sleeve I over Bars G/H and re-insert Adjustment Bar B.
8.
Lock Adjustment Bar B and Pivot Bar C by inserting 1/2" self-
drilling screws J in the holes provided in Pivot Bar C.
9.
Insert Wind Pin K into hole #2 of Pivot Bracket D
to lock the UNIVERSAL Spa Cover Lifter in the open
position during use to avoid personal injury.
To move the spa cover off:
The cover can be easily moved off and of from
inside the spa
other Patents applied for
J
C
B
E
F1
F2
Mounted
on Deck
F1
B
1. flip
2. rotate
D
F2
E
I
G/H
D
K
3. THAT'S IT!
April/2005