- ページ 6

ボイラー AKKAYA-BLOWTHERM SBK-YSB-HYBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AKKAYA-BLOWTHERM SBK-YSB-HYB 20 ページ。 Steam boilers

briquette without letting any air leakage.Side section and backside of the boiler

are being built with brick and briquette as seen the figure to make ash space.

The place where the furnace and reverse chamber is attached (fig 1) ,must be built

by fire bricks.It is height must be as much as explotion doors height.

If the boiler will be used with solid fuel or gas fuel ,concrete step must be

spilled as we make scotch type boiler to the place where the boiler wÕll land and

the boiler must be setted on this concrete step.A hole which the barrel of burner

can enter in ,is drilling on the door of coal inlet.Appropriate parts of assemblying

are done on the connecting flange of the burner.

CONNECTION OF SCOTCH TYPE OF STEAM BOILER

Fig 4 :

Connection of scotch type steam boiler

Fitting up steam boiler and chimney connecting must be done by qualified service.

Attaching safety and control Õnstruments connectings existed Õnstallition.

Similiar services are made by recommended company by qualified service.

The height of the boiler 2m higher than the boiler height.

1 m distance must be between boilers and at least 1 m distance from side wall

of the boiler There must be at least two doors facing each other .one of them

must have ventilation to let to the boiler room.

These doors must be 2 m height and 0.6 m width.These doors must be divided

from other places.The boiler room must be ventilated.Pressure decrase can be max.

0.5 mbar in the boiler room.

Concrete step must be done in appropriate dimensions to the place where landing

boiler and the boiler must be placed there.

A hole which the barrel of the burner can enter in ,is drilling on the door of coal

Appropriate parts of assemblying are done on the connecting flange of the burner.

boiler and the boiler must be placed there.

Burner must be fitted up by these parts.

CHøMNEY CONNECTION

Boiler must be connected chimney by connecting parts which have the same

dimensions of stack connection of the boiler.

The distance between chimney and the boiler must be less than 3m.If it is possible

If you have to use elbow ,you cant use more than two elbows .

Becareful about sharp turning because tar can be formed Õn the chimney by

by chimney fumes pipe.Too long chimney connection pipes in horizantal section

cause poor draft of chimney because of quick cooling .Chimney draft is very

is important for the burning quality .The diameter of chimney must be in appropriate

dimensions for your boiler.

ASSEMBLøNG ACCESSORIES OF STEAM BOøLER

All accessories must have the specifications and quantities as inidicated in norms and standards

The faÕilures caused by the accessories provided by the customer is not at our responsibility and

guarantee conditions do not apply.

Fig. 5 :

Accessories Of Steam Boiler