- ページ 4

アダプター Dixon 4540SGのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dixon 4540SG 8 ページ。 Sight glass kit

ASSEMBLY

1. Install the new o-rings making sure the grooves are clean.

2. Apply o-ring lubricant on the outside face of the sight glass to reduce

friction. Position the new sight glass as shown in figure 5, making sure

that the edge with the chamfer will pass the o-rings first, then press the

sight glass evenly into the bore. If necessary use the old sight glass to

push down the new sight glass.

3. Insert retaining ring into the groove in the body.

4. Verify the new seals and sight glass do not leak by capping one end and

applying low air pressure (3 to 5 PSI) and checking for air bubbles

under water.

Figure 5 – Sight glass assembly

090110 Rev1