ページを印刷するDisplay
Outlets
(covered)
Warning: NEVER operate this inverter unless it is properly grounded.
1.
Open the rubber cover on the receptacle(s) and plug the 115 VAC device(s) you
wish to power into the 3-prong AC Receptacles. See FRONT above. The
appliance(s) must not use more than 2,000 (total) watts during continuous
operation, otherwise it may overload the Inverter.
Caution: Some rechargeable appliances may damage the Power Inverter or
the appliance. When first using a rechargeable device, check the inverter's
temperature for the first 10 minutes. If it becomes abnormally hot, do not use
this device with the Inverter. You should consider using a Pure Sine Wave
Inverter instead.
2.
Flip the Power Switch to the On (I) position to turn on. Do not use the appliance
until the green power LED indicator is on.
3.
Turn on appliance. If an alarm sound is heard, turn off the appliance.
Caution: It is recommended that the vehicle be started every hour to recharge
the battery system. Doing this will help prevent any unexpected shutdown of
the equipment. This will also help ensure that there will be enough battery
power to start the vehicle. Due to the risk of carbon monoxide inhalation (see
Warning # 21 on page 4), do not run the vehicle's engine within an enclosed
area.
4.
After use, disconnect the appliances, flip the Power Switch to the Off (O) position,
and put the rubber covers back in place over the receptacles.
5.
Display:
DC Input Voltage Indicator :
7 Green LED indicate11-15v Range step:0.5V
1 orange LED indicating lower than 11V
1 Red(Bottom) LED indicating lower than 10.5V
1 Red(Top) LED indicating above 15V
Output Power Indicator :
8 Green LED indicate,step 200Watts,up to 1800Watts
1 orange LED indicate,step 1800Watts,up to 2000Watts
1 red LED indicating,The output load is more than 2000Watts
FRONT
Operation
Power
Indicator
Switch
Remote
P
a
g
e
6