AIMS PWRINV1800W 조립 및 작동 지침 매뉴얼 - 페이지 6

{카테고리_이름} AIMS PWRINV1800W에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AIMS PWRINV1800W 9 페이지.

Display

Outlets

(covered)

Warning: NEVER operate this inverter unless it is properly grounded.

Open the rubber cover on the receptacle(s) and plug the 115 VAC device(s) you

wish to power into the 3-prong AC Receptacles. See FRONT above. The

appliance(s) must not use more than 2,000 (total) watts during continuous

operation, otherwise it may overload the Inverter.

Caution: Some rechargeable appliances may damage the Power Inverter or

the appliance. When first using a rechargeable device, check the inverter's

temperature for the first 10 minutes. If it becomes abnormally hot, do not use

this device with the Inverter. You should consider using a Pure Sine Wave

Inverter instead.

Flip the Power Switch to the On (I) position to turn on. Do not use the appliance

until the green power LED indicator is on.

Turn on appliance. If an alarm sound is heard, turn off the appliance.

Caution: It is recommended that the vehicle be started every hour to recharge

the battery system. Doing this will help prevent any unexpected shutdown of

the equipment. This will also help ensure that there will be enough battery

power to start the vehicle. Due to the risk of carbon monoxide inhalation (see

Warning # 21 on page 4), do not run the vehicle's engine within an enclosed

area.

After use, disconnect the appliances, flip the Power Switch to the Off (O) position,

and put the rubber covers back in place over the receptacles.

Display:

DC Input Voltage Indicator :

7 Green LED indicate11-15v Range step:0.5V

1 orange LED indicating lower than 11V

1 Red(Bottom) LED indicating lower than 10.5V

1 Red(Top) LED indicating above 15V

Output Power Indicator :

8 Green LED indicate,step 200Watts,up to 1800Watts

1 orange LED indicate,step 1800Watts,up to 2000Watts

1 red LED indicating,The output load is more than 2000Watts

FRONT

Operation

Power

Indicator

Switch

Remote