AIMS PWRINV1800W 조립 및 작동 지침 매뉴얼 - 페이지 5

{카테고리_이름} AIMS PWRINV1800W에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AIMS PWRINV1800W 9 페이지.

Ground
For the power inverter to work properly, your power source must provide 12 volts
DC, and the power source must provide enough current (i.e., 46 amps to operate
the load of 560 Watts or under).
Caution: This inverter must only be connected to batteries with a nominal
output voltage of 12 volts. Lower voltage will not operate the inverter prop-
erly, and more voltage could damage the inverter or the device being pow-
ered. If more than one 12 volt battery is to be used, the batteries must be
connected in a parallel circuit; 12 volt batteries connected in a series circuit
will produce too much voltage.
1.
Place the Power Inverter on a flat surface. Make sure it has adequate ventilation
and is not in direct sunlight. Fasten the inverter securely to the surface, using
screws or some other means. If holes are to be drilled, follow safe, proper
installation techniques.
2.
Connect the Battery Cable(not included; 1 AWT (1/ 0) recommended)
lugs to the (Positive) red and (Negative) black terminals on the back of the
Inverter, see BACK above. Connect the Ground Cable (not included;
#4 AWG or larger cable recommended) lug to the Ground terminal, see BACK
above. Securely tighten.
3.
The Power Inverter can be used either while the engine is running or off.
Connect the Battery Cables (not included) to the Negative (black) and Positive
(red) terminals of the battery.
4.
Connect the Ground Cable to an earth ground, such as a metal water pipe or
to the vehicle's ground when used in a vehicle.
BACK
Connection
Negative
Positive
P
a
g
e
5