AIMS PWRINV1800W Manual de instruções de montagem e funcionamento - Página 5

Procurar online ou descarregar pdf Manual de instruções de montagem e funcionamento para Inversor AIMS PWRINV1800W. AIMS PWRINV1800W 9 páginas.

Ground

For the power inverter to work properly, your power source must provide 12 volts

DC, and the power source must provide enough current (i.e., 46 amps to operate

the load of 560 Watts or under).

Caution: This inverter must only be connected to batteries with a nominal

output voltage of 12 volts. Lower voltage will not operate the inverter prop-

erly, and more voltage could damage the inverter or the device being pow-

ered. If more than one 12 volt battery is to be used, the batteries must be

connected in a parallel circuit; 12 volt batteries connected in a series circuit

will produce too much voltage.

Place the Power Inverter on a flat surface. Make sure it has adequate ventilation

and is not in direct sunlight. Fasten the inverter securely to the surface, using

screws or some other means. If holes are to be drilled, follow safe, proper

installation techniques.

Connect the Battery Cable(not included; 1 AWT (1/ 0) recommended)

lugs to the (Positive) red and (Negative) black terminals on the back of the

Inverter, see BACK above. Connect the Ground Cable (not included;

#4 AWG or larger cable recommended) lug to the Ground terminal, see BACK

above. Securely tighten.

The Power Inverter can be used either while the engine is running or off.

Connect the Battery Cables (not included) to the Negative (black) and Positive

(red) terminals of the battery.

Connect the Ground Cable to an earth ground, such as a metal water pipe or

to the vehicle's ground when used in a vehicle.

BACK

Connection

Negative

Positive