- ページ 9

照明器具 ClearWater Lights GlendaのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ClearWater Lights Glenda 16 ページ。 Led light kit for bmw k1600gt
ClearWater Lights Glenda にも: インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ)

Step 4: Wiring
Wire Routing:
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
• Use a Posi-lock to connect RED wire from the trident adapter to the thin
RED wire from the relay harness (2 wires).
• Use a Posi-twist to connect GREEN wire from the trident adapter to the
two GREEN wires from the lights (3 wires).
• Use a Posi-twist to connect BLACK wire from the harness relay to the
two BLACK wire from the lights (3 wires).
• Use a Posi-twist to connect RED wire from the harness relay to the two
RED in Glenda, WHITE in Darla wires from lights (3 wires).
• Plug the Trident Adapter into the Data Cable
• Run the RED and BLACK power wire, and Data Cable along the air
intake up to the battery. (Fig.1) and (Fig. 2)
• The BLACK power wire with the ring terminal goes to the negative ( - )
side of the battery. The RED power wire with the inline fuse holder goes
to the
positive ( + ) side of the battery.
Remove the fuse while wiring
the lights to prevent any accidental shorts.
• Plug the Data Cable into the CANopener.
Fig. 1
Fig. 2
Page 9