ClearWater Lights Glenda 설치 매뉴얼 - 페이지 9

{카테고리_이름} ClearWater Lights Glenda에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Glenda 16 페이지. Led light kit for bmw k1600gt
ClearWater Lights Glenda에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

Step 4: Wiring

Wire Routing:

• Be sure to route wires so that they cannot become tangled or caught

in either a suspension part or steering part. Check movement of both

steering and suspension before riding the bike.

• It is sometimes helpful to follow existing wire routing.

• Use a Posi-lock to connect RED wire from the trident adapter to the thin

RED wire from the relay harness (2 wires).

• Use a Posi-twist to connect GREEN wire from the trident adapter to the

two GREEN wires from the lights (3 wires).

• Use a Posi-twist to connect BLACK wire from the harness relay to the

two BLACK wire from the lights (3 wires).

• Use a Posi-twist to connect RED wire from the harness relay to the two

RED in Glenda, WHITE in Darla wires from lights (3 wires).

• Plug the Trident Adapter into the Data Cable

• Run the RED and BLACK power wire, and Data Cable along the air

intake up to the battery. (Fig.1) and (Fig. 2)

• The BLACK power wire with the ring terminal goes to the negative ( - )

side of the battery. The RED power wire with the inline fuse holder goes

to the

positive ( + ) side of the battery.

Remove the fuse while wiring

the lights to prevent any accidental shorts.

• Plug the Data Cable into the CANopener.

Fig. 1

Fig. 2

Page 9