- ページ 3
バイクアクセサリー AltRider Headlight GuardのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。AltRider Headlight Guard 4 ページ。 Headlight guard for bmw f850 gs/adventure
2
Remove the OEM fasteners at the turn signal stocks on both left
1
and right turn signals. The rear fastener is removed using a T30 bit
and 10mm spanner to hold the nylock nut in the rear. These will be
reused. The rear fastener is removed with a T25 bit. This fastener will
be replaced. Twist turn signal stock one quarter turn to remove.
3
Insert turn signal stock through the bracket, and rotate into the correct
position as shown. Insert M5 spacer in between bracket and headlight
assembly, and secure with M5 fastener in the forward hole location with
M3 driver. Resecure T30 fastener while holding the rear nut with a 10mm
wrench. Hand tighten fasteners until secure. Repeat on both sides.
BMW F850 GS /Adventure
Step 2a
Install the (4) custom ball studs into the right and left side
2
brackets. Add a drop of thread locker and hand tighten. hold
the ball studd with 10mm spanner and turn M4 fastener with
2mm hex key. Be careful not to heavily torque the small M4
fastener.
Standard Model
Insert (4) rubber grommets into steel mesh or lexan headlight guard
4
lens. If needed, use a touch of water on the grommet to lubricate.
Once grommets are installed, insert the balled end of the studs into
the rubber grommets, securing the headlight guard to the brackets.
//
//
Headlight Guard
Installation Instructions
Step 2b
Adventure Model