AltRider Headlight Guard 설치 지침 - 페이지 3

{카테고리_이름} AltRider Headlight Guard에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AltRider Headlight Guard 4 페이지. Headlight guard for bmw f850 gs/adventure

Remove the OEM fasteners at the turn signal stocks on both left

and right turn signals. The rear fastener is removed using a T30 bit

and 10mm spanner to hold the nylock nut in the rear. These will be

reused. The rear fastener is removed with a T25 bit. This fastener will

be replaced. Twist turn signal stock one quarter turn to remove.

Insert turn signal stock through the bracket, and rotate into the correct

position as shown. Insert M5 spacer in between bracket and headlight

assembly, and secure with M5 fastener in the forward hole location with

M3 driver. Resecure T30 fastener while holding the rear nut with a 10mm

wrench. Hand tighten fasteners until secure. Repeat on both sides.

BMW F850 GS /Adventure

Step 2a

Install the (4) custom ball studs into the right and left side

brackets. Add a drop of thread locker and hand tighten. hold

the ball studd with 10mm spanner and turn M4 fastener with

2mm hex key. Be careful not to heavily torque the small M4

fastener.

Standard Model

Insert (4) rubber grommets into steel mesh or lexan headlight guard

lens. If needed, use a touch of water on the grommet to lubricate.

Once grommets are installed, insert the balled end of the studs into

the rubber grommets, securing the headlight guard to the brackets.

Headlight Guard

Installation Instructions

Step 2b

Adventure Model