- ページ 5

クワッドコプター dji AGRAS MG SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。dji AGRAS MG Series 17 ページ。 Spreading systems

dji AGRAS MG Series 取扱説明書
e. Connect the cable to the Reserved Expansion Port 2 (7-pin) on the bottom of the aircraft body.
Usage
1. Open the cover of the spread tank as shown, add compatible materials, and close the cover.
2. Power on the remote controller, and then power on the aircraft.
3. Enter Operation View in the app.
4. To set the hopper outlet size, spinner disk rotating speed, and flying speed, tap the Spreading
Settings button
89%
that they are suitable for the materials you are using and test to make sure the performance is as
expected.
For the Spreading System 1.0, when measuring between 7.5 to 9 kg/ha of materials spread, it is
recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 1 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 4 to 6 meters.
• Set the flying speed to 4 m/s (flying speed setting is unavailable in Manual Operation Mode).
For the Spreading System 2.0, when measuring 45 kg/ha of materials spread, it is recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 8 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 5 to 7 meters.
• Set the flying speed to 5 m/s (flying speed setting is unavailable in Manual Operation Mode).
5. Enter the operation mode required for spreading. The operations of the Spreading System vary
depending on the operation mode.
6
© 2020
DJI All Rights Reserved.
, which is located towards the top of the interface. Adjust the settings so
M3×10 (Plus)
M3×12
M3×12