- ページ 6

クワッドコプター dji AGRAS MG SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。dji AGRAS MG Series 17 ページ。 Spreading systems

dji AGRAS MG Series 取扱説明書
Route Operation Mode
After starting an operation, the aircraft ascends to an altitude of 4 meters and the spinner disk
spins. When the aircraft reaches the route starting point, the hopper gate opens according to the
set value and the aircraft flies along the route and spreads material automatically. Spreading cannot
be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused,
the hopper gate closes automatically to stop spreading while the spinner disk is still spinning. After
operation is resumed, the aircraft returns to the breakpoint or projection point and continues spreading.
A-B Route Operation Mode
After the aircraft enters A-B Route Operation Mode, the spinner disk spins. When the aircraft reaches the
first turning point, the hopper gate opens according to the set value and the aircraft flies along the route
and spreads material automatically. Spreading cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused,
the hopper gate closes automatically to stop spreading while the spinner disk is still spinning.
After operation is resumed, the aircraft returns to the breakpoint or projection point and continues
spreading.
Manual Plus Operation Mode
Switch to M+ after the aircraft takes off. Press the Spray button to start the spinner disk. The hopper
gate opens according to the set value and the aircraft spreads material automatically once it has
begun flying.
Manual Operation Mode
Switch to M after the aircraft takes off. Use the Spray button on the remote controller to start or stop
spreading.
In all operation modes except Manual Operation Mode:
• When the aircraft flies forward or backward, the hopper gate opens automatically to start
spreading.
• When the aircraft flies left or right, the hopper gate closes automatically to stop spreading
while the spinner disk continues to spin.
Spreading System Calibration
When to Calibrate
The Spreading System has been calibrated before delivery. There is no need to calibrate it before
using for the first time. Calibration is required in any of the following cases:
• The hopper gate cannot fully open or close.
• The material delivery rate is different from the desired value.
• The app incorrectly displays empty tank warnings.

Calibration Procedure

In the app, enter Operation View. Tap
Spreading System Settings. Wait until the app indicates calibration is complete. If calibration fails,
try again.
at the top of the screen, then tap Calibration in
© 2020
DJI All Rights Reserved.
7