- ページ 13

電動工具 EDILGRAPPA MU 22NのPDF 使用方法とメンテナンスをオンラインで閲覧またはダウンロードできます。EDILGRAPPA MU 22N 20 ページ。 Machine body with interchangeable heads

3. Totally drain the oil tank using a suitable extraction system (used oil extraction pump)

Totally drain the oil tank using a suitable extraction system (used oil extraction pump)

so that no oil can leak into the machine;

4. Loosen the vent screw (fig. 5);

5. Slowly pour in the correct quantity of oil (0.6 l) using suitable equipment (e.g. as shown

Slowly pour in the correct quantity of oil (0.6 l) using suitable equipment (e.g. as shown

in fig. 6). Only use new or clean recommended oil (as indicated on the next page);

6. Fill up to the upper rim of the hole;

7. Put back the oil cap and the vent screw and tighten slightly;

8. Perform some piston strokes to vent the large air bubbles;

9. Move the piston to its maximum extension and rapidly start and stop the motor several

Move the piston to its maximum extension and rapidly start and stop the motor several

times (before the piston automatically retracts);

10. Complete filling;

11. Put back the oil cap and vent screw and tighten (figs. 4 and 5).

Put back the oil cap and vent screw and tighten (figs. 4 and 5).

TOPPING UP THE OIL:

Before unscrewing the magnetic cap to check the oil level, make sure the piston is

fully extended and, if necessary, pull it out. If this is not done the oil may leak, air

extended and, if necessary, pull it out. If this is not done the oil may leak, air

bubbles may form and/or the oil level may be incorrectly measured, thus causing

the machine to operate incorrectly.

Only after completing the above operations, proceed as shown below:

1. Place the machine horizontally in a stable position on a work surface with the filling

Place the machine horizontally in a stable position on a work surface with the filling

hole facing upwards. Place a basin under the machine to catch any oil leaks;

2. Move the piston to its maximum extension and rapidly start and stop the motor s

Move the piston to its maximum extension and rapidly start and stop the motor several

times (before the piston automatically retracts);

3. Unscrew the magnetic cap (see fig. 4) and remove any residues;

Unscrew the magnetic cap (see fig. 4) and remove any residues;

4. Check the amount of missing oil;

5. Loosen the vent screw (fig. 5) and slowly top up to the upper rim of the hole with

Loosen the vent screw (fig. 5) and slowly top up to the upper rim of the hole with

recommended new and clean oil using suitable equipment (e.g.: as indicated in fig. 6);

6. Put back the oil cap and vent screw and tighten (figs. 4 and 5).

VENT SCREW

MAGNETIC CAP

clean oil using suitable equipment (e.g.: as indicated in fig. 6);

shown below:

MU 22N