- ページ 10

メディア・コンバーター AIMS Power CON120AC36/48VDCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AIMS Power CON120AC36/48VDC 12 ページ。 Ac converter / battery charger

ページを印刷する

If any other situations occur that are not listed above, call AIMS Power immediately.

Specifications

4.1

Input

4.1

Input

Input Voltage

Frequency

Nominal Input Current at Rated

Output

Voltage Measurement Accuracy

Frequency Measurement Accuracy ±1Hz

4.2

Output

4.2

Output

Nominal Voltage

Output Current

Rated Output Current

Current Accuracy

Load Regulation

Selectable Battery Type

Parallel Outputs

Efficiency

4.3

Protection

4.3

Protection

Input Over/Under Voltage

Reverse Battery Polarity Protection

Output over voltage

Charger over temperature

protection

96-145VAC full performance

70-96VAC automatically derate to 50% of full load current

40Hz to 70Hz

<9Aac

±8Vac

36/48Vdc manual adjustable

Input voltage 96-145V,

Output current 25A for 36V mode

Output current 18.75A for 48V mode

Input voltage 70-96V,

Output current 12.5A for 36V mode

Output current 9.375A for 48V mode

Manual adjustable

± 6% of full rated output current @25°C, for target currents

across the range from 10% rated output (for absorption exit

criteria accuracy) to the current limit set point.

1.5%

Open Lead-Acid, Gel, AGM, LiFePo4 (see charging voltages)

Maximum of two AC converter units connected in parallel

80%

Unit must be safe for input voltage up to 150VacRMS (and up to 215Vpeak),

need not be operating. Above this level the unit may be damaged. Unit must not

be damaged for all input voltages from 0-300Vac. Shutdown or input current limit

or other means may be applied when input voltage is out of normal operating

range.

Non-destructive reverse battery polarity protection with fuses.

Unit will not sustain damage and will meet all specifications

after fuse replacement.

Unit will shut down if Vcharging > Vcharging (target) +

1.0Vdc/1.5Vdc/2.0Vdc/2.5Vdc for more than 2 seconds; unit will restart when

voltage <= Vcharging (target) for more than 2 seconds. For battery OVP the unit

will restart in the same stage.

The internal temperatures of the charger will be measured by

NTC. Based on these measurements, unit will shut down if the

temperature exceeds 105°C. Unit will restart when

environment temperature cools to 95 °C.

- 10 -