- ページ 9
コントローラー Cleco Tools CellCore P2402KAのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cleco Tools CellCore P2402KA 16 ページ。 Data transmission
ページを印刷する
Abb. 3-1: WLAN AP Configuration
Parameter
Activate WLAN Commu-
nication
SSID
Set default SSID
Password
<Generate Password>
Default Password
Channel bands
2.4 GHz channels
(802.11 b/g/n)
5.2 GHz channels
(802.11 a)
Information to setup cli-
ents for access point
<Identify>
<Apply>
<OK>
<Cancel>
Apex Tool Group
Description
If the checkbox is activated, WLAN is active on the controller.
→ The Bluetooth function is deactivated.
Enter the SSID for the WLAN name (access point) to which a connection is
to be established.
If the Set default SSID checkbox is activated, then a default value for the
SSID is assigned.
Enter the password for the access point.
The default password is visible. As soon as a new password is assigned,
asterisks * are displayed instead of numbers.
Press <Generate Password> to generate any eight-digit password.
If the Default Password checkbox is activated, then the default password is
displayed.
Select the frequency band. Only one channel can be selected.
The following may be selected:
•
2.4 GHz
•
5.2 GHz
Select channel. Only one channel can be selected.
Only active if the 2.4 GHz frequency band has been selected.
Select channel. Only one channel can be selected.
Only active if the 5.2 GHz frequency band has been selected.
Information
to setup clients for access
•
IP address range for tools
•
Subnet mask
•
Gateway
•
WLAN-Encryption
Update the view of the WLAN settings.
Save the settings.
Exit software, the settings are saved.
Exit software, the settings are not saved.
P2402KA | 2019-05
Setting up the mPro200GC-AP
point:
3
EN
9