- ページ 7
コントローラー Cleco Tools CellCore P2402KAのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cleco Tools CellCore P2402KA 16 ページ。 Data transmission
ページを印刷する
2.1.3
Cell planning for access point
Each channel operates with a frequency range of 22 MHz. To avoid overlapping the frequency ranges, the
channels must be chosen so that they do not overlap. In other words, a maximum of 3 independent chan-
nels (e.g., 1, 6 and 11) are available in the 2.4 GHz frequency band.
The 5 GHz frequency band provides up to 21 independent channels.
To minimize interference between different radio cells that share the same RF channel, it is advisable to
physically separate them. Note that for multistory buildings, it is necessary to consider both higher and
lower floors.
The following overview shows the basic channel assignment.
Abb. 2-2: Idealized radio cells
The physical circumference of a radio cell depends primarily on the access point used, the antennas and
the type of construction in the surrounding area. The limit of a radio cell is reached when the signal-to-noise
ratio (SNR) falls below 15 dB. If the ratio falls below this value, a new radio cell should be started. The typi-
cal circumference of a radio cell in a building is up to 50 m.
For the tool to be able to connect to different access points automatically (roaming), the SSID and encryp-
tion must be set identically at the corresponding access points.
If wide-area coverage with controlled emission from multiple access points is required, corresponding
planning and evaluation must be carried out for the specific case.
Example installation 5 GHz
•
Several overlapping radio cells are possible, even if only one free channel is used.
•
Up to 200 tools are then possible within the radio range with a limited volume of data.
•
The range of the radio cells is limited by the minimal transmission power.
Abb. 2-3: Idealized radio cells = Range of use of the tools
2.2
Bluetooth connection
The controller can communicate via the Bluetooth connection with up to seven tools at a time. The tools can
communicate according to the following standard:
Tool
CCBA, CCBP
Apex Tool Group
Channel 1
Channel 6
Channel 60
Channel 60
SSID 2
SSID 3
Channel 60
Channel 60
SSID 6
SSID 7
Standard
Bluetooth 4.2
P2402KA | 2019-05
Area of use of the tools
Channel 11
Channel 60
Channel 60
SSID 5
SSID 4
Channel 60
Channel 60
SSID 8
SSID 9
2
System layout
EN
7