- ページ 3

工具収納 Artillian 1UTVTBPRのPDF インストレーション＆オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Artillian 1UTVTBPR 8 ページ。

WARNING

It is the user's responsibility to ensure that installation of this

product does not affect the functionality of the vehicle ROPS,

tires, or any other safety feature of the vehicle. Failure to do

so may result in injury or death. Due to the many features on

the UTV vehicle, the Bed Mounted Tool Bar or some of its

quick removal accessories may interfere with dump bed

operation, fender flares, or tires. If necessary, the quick-

release Cam Lever Latches on the ROPS Mounted Tool Bar

accessories allow a given accessory to be quickly removed

and relocated to a non-interfering location.

Artillian strives to continuously improve our products. As such, the

actual product may vary from the images shown throughout this

manual.

Note: If installing The Artillian UTV Bed Mounted Tool

Bar on the Polaris Ranger 1000, proceed with the

following steps 1-12. If installing on the Gravely Atlas JSV

3400SD, skip to page 5 and start with step 13.

1. Park the vehicle on a flat, level surface.

2. Open the tailgate. Use a 10mm socket to remove the

left and then right tail lights. See Fig. 2.

3. Per Fig. 3, disconnect the left and right tail lights from

the vehicle. Set the tail lights with mounting

hardware aside for re-use in Step 12 on the next

page.

4. Close the tailgate and tilt the bed back using the

vehicle's bed latch. See Fig. 4.

5. Using a T30 Torx bit, remove (4) screws from the

bottom of the left and right sides of the bed. Set

removed hardware aside for re-use. See Fig. 5.

6. Using a T40 Torx bit, remove the screw next to the

latch handle on the left side and right side of the bed.

Set removed hardware aside for re-use. See Fig. 6.

Fig. 6; Remove Screw Next to Latch Handle

KIT INSTALLATION

Remove Hardware

Fig. 2; Remove Left Tail Light

Fig. 3; Disconnect Left Tail Light

Fig. 4; Tilt Bed Back

Remove Hardware (4 places per side)

Fig. 5; Remove Underside Screws on the Side Panel

3 of 8

Disconnect Connector