- ページ 4

工具収納 Artillian 1UTVTBPRのPDF インストレーション＆オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Artillian 1UTVTBPR 8 ページ。

ページを印刷する

7. Using a T30 Torx bit, remove the (4) screws on the

inside of the left and right side of the bed. When

removing the screws, the side panels will fall off the

bed of the body. Hold the side panels when removing

the screws. See Fig. 7.

8. Put the bed back down. Using (6) of the supplied

5/16" X 6" long bolts and (6) 5/16" washers, use a

1/2" socket to install the left mounting bracket and

backing plate. Repeat this step on the right side of

the bed with right mounting bracket and backing

plate. Torque the 5/16" bolts to 150 (Inch-Pounds)

or 17 (Newton-Meters). See Fig.8.

Note: Make sure that the threaded inserts on the backing

plates are pointed towards the ground as shown in Fig. 8.

9. With assistance, install 42" long tool bar, tube

clamps, and 32" long UTV Tool Rack Vertical Tubes

(supplied in the UTV Bed Mounted Tool Rack) on left

side of bed. Use (4) of the supplied 5/16" X 1" screws

to secure. When placing the tool bar, make sure to

leave a 1" gap between the end of the tool bar and

the ROPS of the vehicle. Repeat on right side. See

Fig. 9.

Note: Make sure that the (2) threaded inserts of the

Vertical tubes are placed on the top/inside of the

assembly.

10. See Installation Manual for Artillian UTV Bed Mounted

Tool Rack (1UTVRK) to complete installation of the

tool rack. Once installation of the tool rack is

complete, finish the below steps to complete this kit

installation.

11. Tilt the bed back. Re-install the bed's side panels

removed on Steps 5-7. See Fig. 11.

Note: When tilting the bed back, grab the tool rack and

slowly allow the bed to tilt back. Do not let it free fall.

12. Close the bed and open the tailgate. Re-install the

tail lights removed in Steps 2 and 3. Close the

tailgate. See Fig. 12. The kit installation is now

complete.

Note: The 5/16" x 1" long bolts & 5/16" flange nuts may

be discarded if the tool bar has been installed on a Polaris

vehicle.

Fig. 12; Re-install Tail Lights

KIT INSTALLATION

Remove Hardware (4 Places)

Fig. 7; Remove Left Tail Light

Mounting Bracket

Inserts on Underside

Fig. 8; Install Left Bracket and Backing Plate

1" gap

Fig. 9; Install Tool Rack's Vertical Tubes.

Fig. 11; Re-install the Bed's Side Panels

4 of 8

Backing Plate

Inside of

tube