- ページ 12

DJ機材 djpower V-3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。djpower V-3 20 ページ。 Spark machine

Manual Mode

Pages

DMX

Configuration

Page

5.4

Wireless Remote-Control Mode & Operation

This mode will allow you to control the Spark Machine V-3 using the wireless controller W-2. This consists of the transmitter and the

receiver. Any one (or more) W-2 transmitter can work with any one (or more) W-2 receiver, no paring procedure needed.

You may control up to 4 independent Spark Machines V-3 or many more if you run them simultaneously. See the below instructions on

setting up your Spark Machine V-3 to operate with the W-2.

LED indicator light

•

Plug the wires receiver into the fog machine 5-pin port labeled "Wireless Controller". The red LED indicator will be on when the transmitter

is successfully connected. There is no any reaction in the green LED indicator

Display

>>>>>>

The longest duration of single time of Manual Spark output is 30

seconds when machine works properly. The machine will automatically

stop after 30 seconds continuous output with LCD showing "Manual

Spark OFF". For longer output, just turn on Manual Spark again.

Dipswitche

Wireless Receiver

DJPOWER

Description

The machine is outputting spark.

The LCD will automatically switch to

this page after Manual Spark is on for

5 seconds.

Press any button, the LCD will go

back to previous page "Manual Spark

ON", and press ▲ or ▼ again to

switch OFF Manual Spark.

Press ▲ or ▼ to set the Spark height

of Manual Spark from level 1

(minimum) to 10 (maximum).

Press ▲and ▼to set the DMX

starting address

>>>>>>

Wireless Transmitter

Parameter

Range

1 - 10

1-512