djpower V-3 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Ді-джейське обладнання djpower V-3. djpower V-3 20 сторінок. Spark machine

djpower V-3 Посібник користувача
Manual Mode
Pages
DMX
Configuration
Page
5.4
Wireless Remote-Control Mode & Operation
This mode will allow you to control the Spark Machine V-3 using the wireless controller W-2. This consists of the transmitter and the
receiver. Any one (or more) W-2 transmitter can work with any one (or more) W-2 receiver, no paring procedure needed.
You may control up to 4 independent Spark Machines V-3 or many more if you run them simultaneously. See the below instructions on
setting up your Spark Machine V-3 to operate with the W-2.
LED indicator light
Plug the wires receiver into the fog machine 5-pin port labeled "Wireless Controller". The red LED indicator will be on when the transmitter
is successfully connected. There is no any reaction in the green LED indicator
Display
>>>>>>
The longest duration of single time of Manual Spark output is 30
seconds when machine works properly. The machine will automatically
stop after 30 seconds continuous output with LCD showing "Manual
Spark OFF". For longer output, just turn on Manual Spark again.
Dipswitche
Wireless Receiver
DJPOWER
Description
The machine is outputting spark.
The LCD will automatically switch to
this page after Manual Spark is on for
5 seconds.
Press any button, the LCD will go
back to previous page "Manual Spark
ON", and press ▲ or ▼ again to
switch OFF Manual Spark.
Press ▲ or ▼ to set the Spark height
of Manual Spark from level 1
(minimum) to 10 (maximum).
Press ▲and ▼to set the DMX
starting address
>>>>>>
9
Wireless Transmitter
Parameter
Range
1 - 10
1-512