- ページ 10

メディア・コンバーター DK-TEC LS6000CのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DK-TEC LS6000C 14 ページ。 Wood splitters 6 and 8 tons

7. After splitting is complete, lift at least one handle, whereby

the splitting head will automatically rise.

8. After splitting, the wood is placed in a separate storage area.

The use of wood splitters, where two people respectively

hold the tree and another drives the splitter head

downwards, is strictly prohibited.

Height settings

The operating energy can be increased by shortening the distance of the cleaver head's backward

movement, for pieces of wood smaller than approximately 50 cm.

Proceed as follows:

Place a low piece of wood on the splitting table and lower the

splitting head to approximately 2 cm above the piece of wood.

Switch off the clover (red button on the switch and pull out the plug).

Now you can shorten the movement of the clevis head by means of

a side bound rod, by fixing the rod in the desired position using the

adjustment screw (see picture).

Electrical/hydraulic connection

Connection:

All clovers are equipped with an undervoltage solution in the contact. This prevents the machine

from starting itself if the power supply is interrupted as a result of a power cut, accidental

disconnection, faulty fuse, etc. The machine must be switched on by pressing the green button.

Deliberately holding or blocking the switch button may lead to failure automatically

power failure. In such case, which can be identified later, the warranty does not apply.

Only for 400 V machines:

The direction of engine rotation (see the arrow on the machine) must be observed, as use with the

wrong direction of rotation can damage the oil pump. In that case, all claims in connection with the

guarantee will not apply.