- ページ 3

3Dプリンター Alunar M508 Prusa i3のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Alunar M508 Prusa i3 6 ページ。 Diy 3d printer kit

Important Notice and Attentions:

1. Keep the assembling operation platform level

2. Please ensure that you move to the right tap position for input voltage (110V or 220V) of the power

supply (as shown in the picture)

Input Voltage

Position choice

3. You need to make a proper degree of tightness of the pull belt for X axis& Y axis

Ensure manual operation slide smoothly when you install the X, Y, Z axis

When equipped the hotbed, you should keep the 4 angle level for sure.

6. Ensure the correct wiring for controller board and plug tightly into the exact socket.

Don't plug and unplug the wiring for controller board when power on, especially don't plug and

unplug the connect wiring for power supply.

8. Don't touch the extruder and hotbed when printer is power on to avoid the scald.

A.Preparatory Work

1. Tool and kit preparing: one level desk at more than 2 sq. m. size, one computer, one scissor, SD card

reader, power supply and so on.

2. Open the box you got, and read the Manual from the SD card. We suggest that you should copy all the

documents to the computer from the SD card and then start assembling according to the manual.

（SD-Card:\）

100~160V

110V

200~260V

220V

Warning:

Must be in

the condition of power

equipment of the

strike.