Alunar M508 Prusa i3 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для 3D-принтери Alunar M508 Prusa i3. Alunar M508 Prusa i3 6 сторінок. Diy 3d printer kit
Друкувати сторінкуImportant Notice and Attentions:
1. Keep the assembling operation platform level
2. Please ensure that you move to the right tap position for input voltage (110V or 220V) of the power
supply (as shown in the picture)
Input Voltage
Position choice
3. You need to make a proper degree of tightness of the pull belt for X axis& Y axis
4.
Ensure manual operation slide smoothly when you install the X, Y, Z axis
5.
When equipped the hotbed, you should keep the 4 angle level for sure.
6. Ensure the correct wiring for controller board and plug tightly into the exact socket.
Don't plug and unplug the wiring for controller board when power on, especially don't plug and
7.
unplug the connect wiring for power supply.
8. Don't touch the extruder and hotbed when printer is power on to avoid the scald.
A.Preparatory Work
1. Tool and kit preparing: one level desk at more than 2 sq. m. size, one computer, one scissor, SD card
reader, power supply and so on.
2. Open the box you got, and read the Manual from the SD card. We suggest that you should copy all the
documents to the computer from the SD card and then start assembling according to the manual.
（SD-Card:\）
100~160V
110V
3
200~260V
220V
Warning:
Must be in
the condition of power
equipment of the
strike.