ページを印刷する6. SETTING OF THE AUTOMATIC CONTROL TIME
Switch to automatic or
random mode.
Press the "K-" button to
select the day of the week.
Press the "MODE" button. The
lowering hour will be displayed.
Hour digits will flash.
Press the "K-" button to
switch to the setting of the
next day.
By pressing the "STOP" button procedure can be canceled.
The symbol "- - : - -" in the automatic control time settings means that the control is not active.
To automatically control receivers from all the channels seting up a group channel on the transmitter is required. Group
channel is active when all channels numbers are highlighted.
In the auto mode interval between lifting and lowering time cannot be less than 32 minutes, otherwise the display will show
"ER:01" error.
4
PROGRAMMING INSTRUCTIONS FOR THE WALL TRANSMITTER: DC1675 AND DC1676
Press and hold "K +" button
for 3 seconds. The lifting hour will
be displayed.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
Repeat the above steps to set
the hours for other days.
By pressing the "UP" or "DOWN"
buttons the settings for each day
of the week can be display.
Press "K+" button.
Minutes digits will flash.
Press "K+" button.
Minutes digits will flash.
Press and hold the "K-"
button for 3 seconds to save
the changes made.
Press the "K +" button again. Hour
digits will flash.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
Saving changes will be
confirmed by three flashys of the
hour and minute digits.
We reserve the right to any technical change.
Valid on 2022.02.09