Aluprof DC1676 Programlama Talimatları - Sayfa 4

Verici Aluprof DC1676 için çevrimiçi göz atın veya pdf Programlama Talimatları indirin. Aluprof DC1676 4 sayfaları.

Sayfayı Yazdır

6. SETTING OF THE AUTOMATIC CONTROL TIME

Switch to automatic or

random mode.

Press the "K-" button to

select the day of the week.

Press the "MODE" button. The

lowering hour will be displayed.

Hour digits will flash.

Press the "K-" button to

switch to the setting of the

next day.

By pressing the "STOP" button procedure can be canceled.

The symbol "- - : - -" in the automatic control time settings means that the control is not active.

To automatically control receivers from all the channels seting up a group channel on the transmitter is required. Group

channel is active when all channels numbers are highlighted.

In the auto mode interval between lifting and lowering time cannot be less than 32 minutes, otherwise the display will show

"ER:01" error.

PROGRAMMING INSTRUCTIONS FOR THE WALL TRANSMITTER: DC1675 AND DC1676

Press and hold "K +" button

for 3 seconds. The lifting hour will

be displayed.

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

Repeat the above steps to set

the hours for other days.

By pressing the "UP" or "DOWN"

buttons the settings for each day

of the week can be display.

Press "K+" button.

Minutes digits will flash.

Press "K+" button.

Minutes digits will flash.

Press and hold the "K-"

button for 3 seconds to save

the changes made.

Press the "K +" button again. Hour

digits will flash.

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

Saving changes will be

confirmed by three flashys of the

hour and minute digits.

We reserve the right to any technical change.

Valid on 2022.02.09