- ページ 2

コントロールユニット CVI SDXのPDF マニュアルをオンラインで閲覧またはダウンロードできます。CVI SDX 7 ページ。 Single disc external spring check valve

•

A minimum of 5 (five) pipe diameters should be maintained between the valve and likely causes of

turbulence (i.e. pump discharge, reducers, elbows, and tees, etc.).

UNPACKING AND INSPECTION

It is important to follow these instructions when unpacking and preparing to use this product:

Preparation for Shipment:

Product packaging and conservation for shipment must be sufficient to protect against deterioration and

physical damage during shipment. CVI valves are normally shipped from the factory in boxes, crates or

on skids. Protruding parts, such as the levers, weights and spring assemblies are sometimes removed

from the valves and either attached to the box or crate or packaged separately. Special shipping

conditions or packaging requirements must be defined in the Customer's Order and shall be appropriate

to ensure safe transportation and conservation before installation.

Inspection of Packaged Product:

Inspect the product packaging for damage while the freight carrier is present. Any observed packaging

damage should be reported to the carrier and a claim created.

Carefully open the shipping container, leaving it intact. Follow any instructions marked on the

container. Carefully remove any packing material and lift the product from the container. The shipping

container and packing material may be kept and reused for product storage or shipment.

Visually inspect the product for signs of possible damage, including missing, broken or loose parts,

scratches, or other forms of damage that may have occurred during shipment. Items that are damaged

during shipment are the responsibility of the purchaser. If damage is observed, file a claim with the

freight carrier immediately. Refer to CVI Terms and Conditions for Sale for our full warranty policy.

Storage:

For short term storage, up to 3 months, keep the product indoors in in the original packaging in a

temperature not below 32

• Do not expose the valve to direct sunlight.

• Do not expose the valve to weather conditions.

• Do not expose the valve to temperature extremes.

• Do not stack the valves on top of each other.

• Keep endcaps on when applicable, and protect the valve against dust, dirt and damage.

For long term storage, the valve should be kept in a clean, heated, weather tight (dry), well-ventilated,

fire-resistant storage facility with flooring that seals against dust and dirt and will not be subject to

flooding.

F or exceeding 85

F. General guidelines for short and long term storage:

P.O. B

12901, WILMINGTON, NC 28405

: 910-794-5547 - F

HONE

EBSITE

WWW

WAFERCHECK

: 910-794-5581

COM