- ページ 10
照明器具 ALUZ ZIBI A1 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ALUZ ZIBI A1 Series 13 ページ。 Surface zuco pivot bios illuminated
ALUZ ZIBI A1 Series にも： 取付説明書 (12 ページ), マニュアル (11 ページ), マニュアル (11 ページ), 取付説明書 (11 ページ)
ページを印刷する1
Determine number of louvers needed. Louvers are available in 1'
increments. Specify total length of reflectors needed.
2
Position louvers on luminaires, then install 3 set screws on each
louver segment to secure in place. Do not over-tighten set screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
3
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
4
Mount luminaires at least 12" away from the wall.
Page 10 of 13
Louver (A1-ZIBI-STN-LVR)
12"
Installation Instructions
9 / 11 / 2023 / Rev 4