ALUZ ZIBI A1 Series 매뉴얼 - 페이지 10
{카테고리_이름} ALUZ ZIBI A1 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALUZ ZIBI A1 Series 13 페이지. Surface zuco pivot bios illuminated
ALUZ ZIBI A1 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지), 매뉴얼 (11 페이지), 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (11 페이지)
페이지 인쇄1
Determine number of louvers needed. Louvers are available in 1'
increments. Specify total length of reflectors needed.
2
Position louvers on luminaires, then install 3 set screws on each
louver segment to secure in place. Do not over-tighten set screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
3
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
4
Mount luminaires at least 12" away from the wall.
Page 10 of 13
Louver (A1-ZIBI-STN-LVR)
12"
Installation Instructions
9 / 11 / 2023 / Rev 4