ページを印刷する
Heater Set Up:
Fig.A
happen at the gas filling station when you fill up the cylinder. Always check this
with your gas supplier.
Fig.B
Fig.C
Push the control knob down for at least
4.
10 seconds, but DO NOT try to ignite the
heater. This will allow gas to flow through
the heater,making the leak test possible.
5.
DO THE LEAK TEST (see next page)
Place the cylinder in the heater cabinet
6.
by securing the rear guard in place.
(Figure D)
This heater makes use of an industrial cylinder (9kg
cylinder recommended) with a 5/8" BSP thread; horizontal
exit valve. The Bullnose regulator
supplied with the heater tightens to the left hand side
(anti-clockwise). (Figure A)
If you have bought a new gas cylinder, the cylinder needs
to be purged (cleared out), before it's first use. If it is not
purged of air, the heater will not work properly. This should
1.
2.
3.
Fig.D
Advise customers to be sure that this is
the product they need before opening
and removing the heater from the
packaging.
Assemble the unit.
Check if the nose cone is present, secure
and in good condition. (Figure B)
1.
The regulator goes directly
into the cylinder valve. Always
make sure the regulator
bottoms fully. The use of any
adaptors is illegal.
2.
Screw the regulator into the
cylinder valve. DO NOT use a
tool to tighten the regulator; it
is to be hand-tightened only.
3.
Open the control valve 1½ turns
to the left (anti-clockwise).
(Figure C)
Fig.E