Alva GH313 Trainingshandleiding - Pagina 4

Blader online of download pdf Trainingshandleiding voor {categorie_naam} Alva GH313. Alva GH313 9 pagina's.

Heater Set Up:

Fig.A

happen at the gas filling station when you fill up the cylinder. Always check this

with your gas supplier.

Fig.B

Fig.C

Push the control knob down for at least

10 seconds, but DO NOT try to ignite the

heater. This will allow gas to flow through

the heater,making the leak test possible.

DO THE LEAK TEST (see next page)

Place the cylinder in the heater cabinet

by securing the rear guard in place.

(Figure D)

This heater makes use of an industrial cylinder (9kg

cylinder recommended) with a 5/8" BSP thread; horizontal

exit valve. The Bullnose regulator

supplied with the heater tightens to the left hand side

(anti-clockwise). (Figure A)

If you have bought a new gas cylinder, the cylinder needs

to be purged (cleared out), before it's first use. If it is not

purged of air, the heater will not work properly. This should

Fig.D

Advise customers to be sure that this is

the product they need before opening

and removing the heater from the

packaging.

Assemble the unit.

Check if the nose cone is present, secure

and in good condition. (Figure B)

The regulator goes directly

into the cylinder valve. Always

make sure the regulator

bottoms fully. The use of any

adaptors is illegal.

Screw the regulator into the

cylinder valve. DO NOT use a

tool to tighten the regulator; it

is to be hand-tightened only.

Open the control valve 1½ turns

to the left (anti-clockwise).

(Figure C)

Fig.E