- ページ 10
ウォーターヒーター Alva GW205のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Alva GW205 14 ページ。 Portable gas water heater
ページを印刷する
USING YOUR WATER HEATER
1.
Push the ON/OFF switch to the ON position
2.
Open the water tap or valve.
3.
The ignition will start automatically, and the burner will light.
4.
Turn the gas flow adjustment knob either clockwise or
anti-clockwise to control the desired water temperature.
(turn clockwise for higher temperature; turn anti-clockwise
for lower temperature)
5.
You can view the flame condition through the flame view
hole. The flame should be blue under normal conditions.
If the flame is yellow, the cylinder may be low on fuel,
change the gas cylinder as soon as possible.
6.
The exhaust gas is vented from the openings at both sides.
The temperature of exhaust gas is very hot, to avoid serious
injury never touch these openings. Keep the tube and hole
clear to make sure the exhaust gas can be vented smoothly.
7.
Hot water will flow from the pipe, the water may be used
for washing hands, showering, dishes, etc. (Will NOT reach
boiling point)
8.
After using the unit, shut off the water sources first and then
turn the power OFF.
Fig.H
Fig.I
8
Take note: On first
lighting a new cylinder
or connecting a cylin-
der after it has been
refilled; you may have
to depress the control
valve for a longer
period of time.
The ignitor will be
started only when the
water flow is 2L/min or
more.
Change the batteries if
you cannot hear
a continuous opera-
tional sound from the
heater.
Never attempt to
remove the regulator
if the water heater is
on or if the cylinder
valve is
not properly closed.
Keep children away to
avoid injury.
Should excessive
amounts of black
smoke be vented from
the holes, shut off the
water heater.
Clean the unit before
use. Fill the water bag
or water pot with
potable water,turn the
flame adjustment knob
to "MAX" position,let
the unit run for about
2 minutes, do not use
the hot water produced
during this time.