- ページ 4
ミュージックペダル Aion Electronics FlareのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aion Electronics Flare 6 ページ。 Fuzz factory
Build Instructions
For most circuits, I recommend fitting the potentiometers to the enclosure first and then fitting the PCB onto
the pots. This prevents stress on the PCB. With five to eight 9mm potentiometers on the Flare, though, this is
extremely difficult! Please see the recommended build order below.
Build Order
1. Attach the audio jacks, DC jack and footswitch to the enclosure.
2. Push the LED
into the hole in the enclosure with the leads sticking straight up, ensuring that the flat side
1
is oriented according to the silkscreen on the PCB.
3. Affix the 9mm pots to the PCB, but don't solder them yet. It helps to bend the two side tabs out slightly so
they latch into the holes better.
4. Fit the PCB + pots into the drilled holes in the enclosure, taking care that the LED leads end up in the
proper holes. If it doesn't fit, or if you need to bend things more than you think you should, double-check
the alignment of the pots and switches.
5. Once you feel good about everything, solder the pots and LED from the top as the last step before
wiring. This way there is no stress on the solder joints from slight misalignments that do not fit the drilled
holes. You can still take it out easily if the build needs to be debugged, but now the PCB is "custom-fit" to
that particular enclosure.
6. Wire everything according to the wiring diagram on the last page.
For the LED: You can use a bezel if you'd like, but generally it's easier just to drill the proper size of hole
1
and push the LED through so it fits snugly. If you solder it directly to the PCB, it'll stay put even if the hole is
slightly too big. Make absolutely sure the LED is oriented correctly (the flat side matches the silk screen) before
soldering, as it'll be a pain to fix later! After it's soldered, clip off the excess length of the leads.
"RPD" and "LEDR" resistors
The resistors marked "RPD" and "LEDR" are generally not original to the circuit and can be adjusted to
preference. "RPD" is the pulldown resistor to help tame true-bypass popping, while "LEDR" controls the
brightness of the LED. I generally use 2.2M for the pulldown resistor and 4.7k for the LED resistor.
Sockets
Since double-sided boards can be very frustrating to desolder, especially components with more than 2 leads,
it is recommended to use sockets for all transistors and ICs. It may save you a lot of headaches later on.
FUZZ FACTORY / FLARE FUZZ
4