ページを印刷するMidi-to-CV/Gate A-190-2
5. Operation
To adjust the A-190-2 parameters one has to enter the
Learn mode and send the regarding Midi messages to the
module from the Midi transmitter while the A-190-2 is in
learn mode. To enter the learn mode one has to press the
learn button and hold it pressed down for about one second.
The one-second-delay was programmed to prevent the
unintentional release of the learn mode. Whenever the LED
is flashing without incoming Midi messages the learn mode
is active. In this mode the A-190-2 is looking forward to an
incoming Midi note on, program change or control change
event (see table below). If one has entered the learn mode
by mistake one can leave it by pressing the learn button
again. The learn mode is also be terminated if one of the
Midi events in the table below is received.
While the A-190-2 is in learn mode the parameters listed in
the table on the next page can be adjusted via incoming
Midi messages.
Whenever the A-190-2 receives one of the Midi messages
listed in the table the parameter in question is changed and
the A-190-2 returnes to the normal play mode, i.e. the LED
stops flashing.
Pay attention that not unintentional Midi messages appear
while beeing in the learn mode (e.g. from a sequencer) as
you change the settings of the A-190-2 with such messages.
All parameter changes made while beeing in the learn mode
6
System A-100
are stored non volatile parameter memory. When the A-190-
2 is turned on next time the parameter settings are taken
from this memory.
DOEPFER
DOEPFER
DOEPFER
DOEPFER