DOEPFER A-190-2 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Синтезатор DOEPFER A-190-2. DOEPFER A-190-2 13 сторінок.

Midi-to-CV/Gate A-190-2

5. Operation

To adjust the A-190-2 parameters one has to enter the

Learn mode and send the regarding Midi messages to the

module from the Midi transmitter while the A-190-2 is in

learn mode. To enter the learn mode one has to press the

learn button and hold it pressed down for about one second.

The one-second-delay was programmed to prevent the

unintentional release of the learn mode. Whenever the LED

is flashing without incoming Midi messages the learn mode

is active. In this mode the A-190-2 is looking forward to an

incoming Midi note on, program change or control change

event (see table below). If one has entered the learn mode

by mistake one can leave it by pressing the learn button

again. The learn mode is also be terminated if one of the

Midi events in the table below is received.

While the A-190-2 is in learn mode the parameters listed in

the table on the next page can be adjusted via incoming

Midi messages.

Whenever the A-190-2 receives one of the Midi messages

listed in the table the parameter in question is changed and

the A-190-2 returnes to the normal play mode, i.e. the LED

stops flashing.

Pay attention that not unintentional Midi messages appear

while beeing in the learn mode (e.g. from a sequencer) as

you change the settings of the A-190-2 with such messages.

All parameter changes made while beeing in the learn mode

System A-100

are stored non volatile parameter memory. When the A-190-

2 is turned on next time the parameter settings are taken

from this memory.

DOEPFER