- ページ 4

メディア・コンバーター Cyenne Audio CY-3100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cyenne Audio CY-3100 18 ページ。 High performance digital to analogue converter

DESCRIPTION

The CY-3100 DAC is an advanced digital to analogue converter capable of playing digital audio up till 192

kHz/24bit samples by using coax SPDIF and 96 kHz by using the other inputs. The build-in microprocessor

will remember your settings and automatically adjust the internal components for maximum performance

for every sample rate. All incoming digital audio is placed in a buffer memory and retimed to eliminate any

jitter the input signal might have for the best possible sound.

Digital audio is available from computers, CD players, most DVD players and media players.

A. Two SPDIF inputs with coax connector. Coax SPDIF is usually the best and reliable way to

transport digital audio. This is the recommended way to connect your digital source.

B. One optical connector. This is mostly for computers and older CD players if they only offer

optical signal. Only use when nothing else is available.

C. One USB connector to connect your computer. When connected to a computer, the computer

has access to it as a sound card device. The maximum sample rata support by the USB sound is

96 kHz as it's designed to offer a driver-less installation. Just plug, wait a few seconds and go. No

software downloads, no driver disks needed.

To Connect the DAC to an amplifier or headphones.

D. One line-out to connect to amplifier. Using the volume control, you can directly connect to an

end-amplifier if desired.

E. One headphones connector. Headphones should have an impedance of 32 Ohm or higher for

good results. Check your headphones specifications. Do not directly connect loudspeakers as

this result in poor sound quality and might damage the DAC after a while.

To connect the power cord.