- ページ 10

フィットネス機器 Dogtra Edge RTのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dogtra Edge RT 17 ページ。 Remote controlled dog training collars
Dogtra Edge RT にも：設定マニュアル (6 ページ), オーナーズマニュアル (15 ページ), 製品マニュアル (14 ページ)

ページを印刷する

8. Charging the Battery

1. Lift the rubber-charging cap and plug in the charger.

2. Plug the adapter's power plug in to a standard AC

wall outlet. The LED indicator on the transmitter and

receiver/collar will turn red.

3. When the unit is fully charged, the LED indicator will

turn green on both the transmitter and receiver/collar.

Unplug the adapter's power plug from the AC wall

outlet and disconnect the charger from the unit.

4. Place the rubber-charging cap back over the charging

port.

* The transmitter and receiver/collar rubber-charging cap

ensures dirt and debris does not build up in the charging

port area. The unit is waterproof even if the rubber-

charging cap is not fully closed.

Using the EDGE RT as a 2 or 3 Dog System

To charge multiple receivers/collars and a transmitter,

combine additional splitter cables as shown above.

Connect 2 splitter cables together to charge all parts of

a 2-dog system, or connect 3 splitter cables together to

charge all parts of a 3-dog system, at the same time.

* Warning

1. Fully charge the unit before the first use.

2. Do not charge the unit near any flammable substances.

3. Fully charge the unit before storing for one month or

longer.

4. Always use Dogtra approved charging adapters.

9. How to Change the Length of the Contact Points

The Dogtra EDGE RT comes equipped with standard

5/8" contact points that can be extended to 3/4" contact

points, for use with dogs with longer coats.

To increase the contact point length from 5/8" to 3/4",

follow the steps below.

1. Using the included adjustment tool with the side marked

5/8", unscrew the contact points counter-clockwise.

2. Place the contact point extension over the exposed

threads, flat side down.

3. Place the contact points over the extensions and tighten

the contact points and extensions clockwise using the

adjustment tool with the side marked 3/4".