- ページ 12

ペットケア製品 Dogtrace DOG GPS X20のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dogtrace DOG GPS X20 19 ページ。

3. By arrows

(collar). Free position (where there is no paired transmitter) indicates lettering

on the LCD.

4. Hold the button CODE again for 2 seconds.

5. Move the transmitter close to the receiver.

6. When paired the LCD shows lettering

to which you´ve paired the transmitter).

7. If you need to pair another transmitter, follow the procedure from the step 3.

8. To finish the regime of pairing – coding press the button

Note: To delete one of the paired transmitters (collars) from the receiver memory,

perform pairing without switched on transmitter. After about 10 seconds, there will

be displayed lettering

7.5 Digital compass calibration

To display accurate direction to the transmitter collar, it is important to perform the

calibration properly. If the device does not show correct direction even with maximum

precision GPS (3 lines on both signal indicators GPS on the display), it has not been

probably calibrated for long time or has been calibrated incorrectly.

WARNING: Always perform calibration outdoors, away from objects that emit mag-

netic fields - buildings, cars, overhead and underground power lines.

Starting calibration

If you know the direction towards to the magnetic north, you can go directly to second

step.

1. Press simultaneously two bottom buttons

calibration. Then repeatedly rotate the device around each of the three axes (picture

no. 1). To finish calibration press the back button. For more accurate calibration,

continue to step 2.

2. Using the compass on the display, look up the north and turn the receiver so that the

antenna faces the north (picture no. 2). Press simultaneously two bottom buttons

and

for 2 seconds - to start the calibration.

picture no. 1

choose the position, to which you want to pair the transmitter

at choosen position.

až

(according to the choosen position,

and

for 2 seconds - to start the

picture no. 2