- ページ 12

ペットケア製品 DogWatch Hidden Fence SystemのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DogWatch Hidden Fence System 14 ページ。
DogWatch Hidden Fence System にも：オーナーズマニュアル (15 ページ)

ページを印刷する

.................................

How The DogWatch System Works

The boundary wire creates the perimeter for the DogWatch Hidden Fence System, and

can enclose any area up to 200 acres. It is buried at least 3 - 4" beneath the surface of

the yard or can lie on top of the ground (e.g.: in wooded or rocky areas). It can also be

installed around gardens or swimming pools, or attached to an existing fence to prevent

your dog from digging under or jumping over it.

Twisted Wire

Transmitter

& Surge

Protector

Boundary Wire

Signal Field

Garden Loop

Boundary Wire: The boundary wire carries the coded radio signal around the perimeter of

your property. It is rated for underground burial.

Signal Field: The radio signal is transmitted from the boundary wire in all directions. It can

be used to keep dogs in or out of an area. The signal is adjusted by the Range control on

the Transmitter to create a signal field on each side of the wire. Your Dealer has installed

the wire to the recommended width of 8-10 feet and has carefully configured the corners to

avoid sharp angles.

Continuous Loop: In order for the system to work properly, the boundary wire must

form a continuous loop. Any break in the wire will cancel the signal field. If the bound-

ary wire is broken or unplugged, the green Loop Monitor Display (LMD) light will go

out and an audible warning will sound. Most breaks are caused by lawn/garden equip-

ment. If you cannot visibly locate the break, contact your Authorized Dealer for serv-

ice.

Surge Protector: For maximum protection against power surges, DogWatch offers

both internal an external surge protection. It is important that the surge protector be

properly grounded. This part of the system protects the transmitter from damage due

to lightning power surges. Your Dealer has attached it to the existing electrical source

house ground or a grounding rod and then connected it to the twisted wire between the

transmitter and the boundary wire.

After a lightning storm, check to be sure your transmitter is working properly.

Do not let your dog outside until you know the system is operating.

.................................